The specialist for fastening technology

 
 
 

 

KonstruX XT SL1 & SL 2

TemplateCase SL 1 for KonstruX Ø 6.5 mm; TemplateCase SL 1 for KonstruX Ø 8,0 mm

 

The case set consists of a top part and four bottom parts, a set of mounting screws and a long bit.

This means that when a beam is mounted the next beam can be pre-mounted on the ground.

Using the top and bottom part: The bottom parts are used with main and secondary beam connection, for example, as a support aid. The set of screws is used to install the bottom parts and as a tension bolt to avoid clearances between the beams.

The screws are countersunk with the long bit, where necessary. The upper part is fitted with fixing drill holes in order to achieve an even clearance for screwing the KonstruX screws in the connection of main and secondary beams.

The screw clearance can be set individually in this way and fixed, the screwing angle is preset and cannot be changed because it is a fixed angle value

 
 
Art. no. Designation Dimensions
945453 KonstruX Setzlehre SL1; Aluminium for 33/128 Inch screws
945452 KonstruX Setzlehre SL2; Aluminium for 5/16 Inch screws
 
 
 


Suitable products

Assembly bracket MW 1-4

KonstruX fully threaded screw Countersunk head Ø 7⁄16" with AG tip

 


Other products in this category KonstruX

Eurotec

KonstruX ST fully threaded screw Countersunk head

Eurotec

KonstruX ST fully threaded screw Cylinder-head