The specialist for fastening technology

 
 

SonoTec, sound insulation cork

Schallschutzkork_Neuheitentext_grauer Hintergrund_320x200px.png
« Back
27.08.2018

SonoTec, sound insulation cork

The SonoTec soundproof cork is a combination of the components cork and natural rubber. This product is suitable for the application of vibration damping where very high isolation values are required and can be used as invisible insulators (pads/strips) with a low resonant frequency and medium to low load.

 Advantages
• Sustainable material
• High load capacity
• Invisible
• Easy to use 

Instructions for use 
The soundproof cork can be used variably. Laying the cork requires no additional training. It can be used as a separating layer between a wooden framework and concrete floor as well as end plates,. It can also be used as a support for lubricants in the roof, as a separating layer between interior and exterior walls in solid wood construction and many other areas where a sound reduction is required.
The cork is either laid on the floor in the appropriate position or prefixed with clamps on the wooden framework. For this we recommend our EuroTec Hammer stapler as well as our Hammer stapler staples measuring from 10 mm in length. Due to the small diameter of the brackets these are not to be regarded as sound bridges. The respective loads that need to be recorded must be determined by a structural engineer or structural engineer.

Further product information can be found on our homepage.
If you require further information, please contact us by phone +49 2331 6245-0 or by email.

We will be happy to give you advice and make you a non-binding offer!

Your Eurotec Team