BRUTUS threaded rod

Steel, electrogalvanised

BRUTUS — for use in new and existing properties
High internal stresses occurring in large timber components such as building trusses, for example, often become too great to be absorbed by the timber alone. As timber is relatively weak in the direction perpendicular to the grain, it is particularly at risk due to transverse shear and must bereinforced in such cases. 

BRUTUS threaded rods absorb these transverse-shear forces!

They are applied both in new constructions (when building the trusses) and in renovations. Whereas in new constructions they allow larger spans and/or narrower timber cross sections, in renovations they help to safeguard the existing structure. Many trusses therefore do not need to be replaced or doubled up at considerable expense, even if they exhibit obvious cracking. In such cases, however, an expert report must always be obtained. 
BRUTUS threaded rods can be shortened to any desired length but should be pilot-drilled to 13 mm. Care must be taken to avoid drill wander when drilling the holes.

It is used for transverse-shear reinforcement:

• Of building trusses 
• At notches and openings
• At transverse connections

Things to bear in mind 

• Pilot-drill to Ø 13 mm 
• The drill bit can wander while drilling deeper holes
• Can be shortened as required!